Precautions For Use Of Automatic Self-priming Pump

Notes on the use of an Automatic Self-priming Pump :

1. First of all, do not loosen the bolts everywhere, and connect the power cord and plug firmly, otherwise the insulation resistance of the motor must exceed 2M.

2. When the self-priming pump is running, the working voltage range should be 5-12 of the rated voltage. Otherwise, the life of the motor will be shortened, and it may be burned out in severe cases.

3. When using an electric pump far from the power supply, the transmission line must be properly thickened. Otherwise, the voltage will drop and it will not work properly.

4. When using the clean water pump and the automatic water suction pump tube, please make sure to pour the water into the water storage tank. If the water does not drain automatically even after turning on the power for tens of seconds, there is no need to add water after use.

5. During use, please keep the motor dry, but please be careful not to drop the water level or expose the bottom valve to the water. When the temperature is below 40 degrees. Prepare antifreeze. Otherwise, the pump body will freeze and crack.

6. During use, please keep the motor dry, but please be careful not to drop the water level or expose the bottom valve to the water. When the temperature is below 40 degrees. Prepare antifreeze. Otherwise, the pump body will freeze and crack.

7. If the pump has not been used for a period of time, drain the water accumulated in the pump, clean the main parts, and apply anti-rust oil in a well-ventilated and dry place.