Jet Water Pump Factory Introduces The Precautions For Installing A Booster Pump

Jet Water Pump Factory introduces the precautions for installing a booster pump:

1. Before installation, we need to carry out a detailed inspection of each of its parts, whether its parts are tightly connected, whether there is any looseness, and whether there is any foreign body blockage in the flow channel of the pump body, so as to avoid During the later installation, there will be situations that cannot be cleaned up. When installing, we need to ensure that it is installed vertically or horizontally. The direction of water flow needs to be consistent with the direction of the arrow displayed on the pump body. The booster pump should be installed as close to the water level as possible.

2. If conditions permit, it is recommended that you add an extra valve at home. The purpose of this is to facilitate future maintenance. In addition, we also need to install a constant pressure gauge outside the pump outlet, so that we can check whether the booster pump is used within the rated head and flow range, which can also effectively extend the service life of the booster pump

3. When installing, we need to follow the correct installation sequence and related installation standards. It must be installed horizontally or vertically in the "Installation Mode" display. When the liquid level to be sucked is lower than the upper-end surface of the impeller of the domestic booster pump or the shaft of the pump, the household booster pump should be installed with a check valve, and the outlet end should be connected with a tee for water diversion. Fill with water and tighten the plug.

4. The connections between the pipelines should be tight and not loose, especially the water inlet pipeline should not leak, otherwise the head of the pump will be reduced or the water cannot be pumped. Before the cavity of the household booster pump is not filled with water, please do not run it continuously for a long time, so as not to damage the seal. In order to ensure our safe use, it is recommended that you must use a three-core safety socket with a grounding wire.