Agricultural Centrifugal Pump Manufacturers Teach You How To Clean The Pump

The vertical agricultural centrifugal pump has been used for a long time and must be cleaned. The following is introduced by ZHELI Booster Pump Manufacturers.

1. The agricultural centrifugal pump manufacturer pointed out that when the vertical agricultural centrifugal pump is started, once it is found that the total flow is not enough or the pump head cannot meet the requirements, it may be reversed. After the two are exchanged with each other, connect and restart.

2. The agricultural centrifugal pump manufacturer pointed out that the vertical agricultural centrifugal pump should have operator management methods, and regularly maintain whether there is any problem with the cognitive resistor between the vertical agricultural centrifugal pump winding and the casing, and it should not be lower than 0.5 kohm, less than the standard value Be sure to remove it and dry the stator of the motor. After the insulation layer is electrically lifted, it can be carried out.

3. After the vertical agricultural centrifugal pump is used for 300-500 hours, the oil inlet screw on the abdomen should be opened, and filled with No. 10 automobile engine oil, and the mechanical seal should be used to maintain a good lubrication state.

4. After the vertical agricultural centrifugal pump is disassembled and overhauled, the sealing characteristics need to be checked by an airtight test.

5. The elbow and the vertical agricultural centrifugal pump are separated and placed in a crate, and the elbow is installed on the vertical agricultural centrifugal pump. If the motor and the pipeline are connected, there is no need to assemble the elbow.

6. When tightening the screws of the vertical agricultural centrifugal pump, the force should be even and symmetrical, and the motor rotor should be rotated while tightening. When the screen is stuck, the vertical agricultural centrifugal pump should send off the anchor bolts and tighten them again.

7. The drive shaft cannot bear any axial vertical force, and side drive forms such as conveyor belts and transmission chains are prohibited.

8. The drive shaft with a high bottom plate is connected to the motor shaft by a coupling or a chain coupling.

9. The vertical agricultural centrifugal pump needs to figure out the higher speed rotation and the higher speed rotation of the fieldwork.

10. Let the liquid enter the channel, it is best not to run dry and high speed, so as not to cause damage to the application.